TukanCAD.com
Camper conversions · Template #90

Plan the complete swing of a swivel kitchen beside the door.

The kitchen is used inside and outside the van. Its dimensions matter, but so does the space it sweeps through while turning.

Go to the steps ↓

The CAD editor and templates are free to use.

Swing-out vehicle kitchen
An original CAD preview of the matching template. Both positions are shown for a moving design.
#90Template
100 × 50 × 88 cmStarting design
Your dimensionsFit the design to your space.
01

What to measure before designing

Measure between finished surfaces and allow for your actual equipment. Note the openings and passages through which the assembly must fit.

01

Measure the doorway, sill and nearby furniture around the proposed rotation axis.

02

Mark the closed frame and its fully turned position on a floor plan.

03

Measure the actual appliances and the working space above the countertop.

A common planning mistake

Clearance in the final outdoor position does not guarantee clearance throughout the swing. Appliance connections depend on the actual equipment.

02

Starting template dimensions

100 × 50 × 88 cm

These are the initial design values in the order of its dimension fields, not automatically its usable internal space. Check each axis meaning in the template labels.

03

From measurements to your own design

  1. Open the matching template.Inspect its details, starting dimensions and supported material options. Choose the option you intend to use.
  2. Adjust dimensions to your measurements.Use the dimension fields or dimension labels in the template details. Follow the field names and include a unit such as cm. Compare the entered values with the updated preview.
  3. Insert the design and inspect it from every side.Switch panels and infills on and off to inspect the frame itself. For a moving design, check its individual positions. Follow the editor instructions before another dimension change.
  4. Save your own assembly.After checking dimensions, save the project. Prepare the parts list and drawings from the adjusted assembly, not from the original example.

CAD operation guides →

04

What to check in the completed design

  • Inspect intermediate turning positions, not just the two end positions.
  • Check access to the upper and lower axis supports.
  • Compare the design with the movement of open doors and surrounding equipment.

This guide helps plan the dimensional layout. Actual materials, hardware, attachments and load capacity depend on the finished construction; the preview alone does not establish them.

Your next step

Fit the design to your space.

Open the starting template and enter values from your own measurements. The link keeps the standard starting construction.

Open the template in CAD ↗View template details →

Related practical guides

All practical guides →