TukanCAD.com
Camper conversions · Template #81

Plan a U-shaped dinette that converts into a bed.

The same footprint must provide seating, table access and sleeping space. Assess the layout in both dining and sleeping positions.

Go to the steps ↓

The CAD editor and templates are free to use.

In the case of seating with conversion to bed
An original CAD preview of the matching template. Both positions are shown for a moving design.
#81Template
180 × 150 × 74 cmStarting design
Your dimensionsFit the design to your space.
01

What to measure before designing

Measure between finished surfaces and allow for your actual equipment. Note the openings and passages through which the assembly must fit.

01

Measure the complete seating area between the van lining and surrounding furniture.

02

Compare cushion depth with legroom and access to the central area.

03

Measure the intended table height and the thickness of both seat and bed cushions.

A common planning mistake

Z is the dining table height, not the seat height. In its lower position, the centre frame also rests on perimeter supports.

02

Starting template dimensions

180 × 150 × 74 cm

These are the initial design values in the order of its dimension fields, not automatically its usable internal space. Check each axis meaning in the template labels.

03

From measurements to your own design

  1. Open the matching template.Inspect its details, starting dimensions and supported material options. Choose the option you intend to use.
  2. Adjust dimensions to your measurements.Use the dimension fields or dimension labels in the template details. Follow the field names and include a unit such as cm. Compare the entered values with the updated preview.
  3. Insert the design and inspect it from every side.Switch panels and infills on and off to inspect the frame itself. For a moving design, check its individual positions. Follow the editor instructions before another dimension change.
  4. Save your own assembly.After checking dimensions, save the project. Prepare the parts list and drawings from the adjusted assembly, not from the original example.

CAD operation guides →

04

What to check in the completed design

  • Check entry into the seating area with the tabletop installed.
  • In sleeping mode, check how the centre section meets the side benches.
  • Keep access to storage spaces and to the mechanism below the table.

This guide helps plan the dimensional layout. Actual materials, hardware, attachments and load capacity depend on the finished construction; the preview alone does not establish them.

Your next step

Fit the design to your space.

Open the starting template and enter values from your own measurements. The link keeps the standard starting construction.

Open the template in CAD ↗View template details →

Related practical guides

All practical guides →